Grand Cherokee 2WD V8-4.7L VIN J (2004)
Wiper Arm: Service and Repair
Wiper Arm Park Ramp Replacement
WIPER ARM PARK RAMP
REMOVAL
1. Disengage the rear wiper arm support from the wiper arm park ramp on the right side of the liftgate just below the liftgate flip-up glass.
2. Lift the wiper arm and blade away from the liftgate until the wiper arm hinge is in its over-center position.
Fig. 17 Wiper Arm Park Ramp Remove/Install
3. Remove the screw that secures the wiper arm park ramp to the liftgate outer panel.
4. Remove the wiper arm park ramp from the liftgate outer panel.
INSTALLATION
1. Position the wiper arm park ramp onto the liftgate outer panel.
2. Install and tighten the screw that secures the wiper arm park ramp to the liftgate outer panel. Tighten the screw to 7 Nm (60 in. lbs.).
3. Lower the rear wiper arm and blade and place the wiper arm support onto the wiper arm park ramp.
