Grand Cherokee 2WD V8-4.7L VIN N (2000)
Driver/Vehicle Information Display: Service and Repair
Compass Demagnetizing
COMPASS DEMAGNETIZING
Degaussing Tool 6029
A degaussing tool (Special Tool 6029) is used to demagnetize, or degauss, the overhead console forward mounting screw and the roof panel above
the overhead console. Equivalent units must be rated as continuous duty for 110/115 volts and 60 Hz. They must also have a field strength of over
350 gauss at 7 millimeters (0.25 inch) beyond the tip of the probe.
To demagnetize the roof panel and the overhead console forward mounting screw, proceed as follows:
1. Be certain that the ignition switch is in the OFF position, before you begin the demagnetizing procedure.
2. Connect the degaussing tool to an electrical outlet, while keeping the tool at least 61 centimeters (2 feet) away from the compass unit.
3. Slowly approach the head of the overhead console forward mounting screw with the degaussing tool connected.
4. Contact the head of the screw with the plastic coated tip of the degaussing tool for about two seconds.
5. With the degaussing tool still energized, slowly back it away from the screw. When the tip of the tool is at least 61 centimeters (2 feet) from
the screw head, disconnect the tool.
