Grand Cherokee 2WD V8-4.7L VIN N (2000)
Amplifier: Service and Repair
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unlatch and lift the right rear seat cushion to the upright position.
Power Amplifier Remove/Install
3. Disconnect the two right body wire harness connectors from the connector receptacles on the right end of the power amplifier.
4. Remove the three nuts that secure the power amplifier to the three studs on the floor panel.
5. Remove the power amplifier from the three floor panel studs.
INSTALLATION
1. Position the power amplifier onto the three floor panel studs.
2. Install and tighten the three nuts that secure the power amplifier to the three studs on the floor panel. Tighten the nuts to 11.8 Nm (105 in. lbs.).
3. Reconnect the two right body wire harness connectors to the connector receptacles on the right end of the power amplifier.
4. Lower the right rear seat cushion to the floor panel.
5. Reconnect the battery negative cable.
