Grand Cherokee 2WD V8-4.7L VIN N (2000)
Power Seat Switch: Service and Repair
Power Seat Switch Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. On models with the ten-way power seat system only, using a trim stick or another suitable wide flat bladed tool, gently pry the power seat and
power recliner switch knobs off of the switch stems.
3. Remove the three screws that secure the outboard seat cushion side shield to the seat cushion frame.
4. Pull the outboard seat cushion side shield away from the seat cushion frame far enough to access the power seat switch wire harness connector.
5. Disconnect the power seat wire harness connector from the power seat switch connector receptacle.
Power Seat Switch Remove/Install - Typical
6. Remove the two screws that secure the power seat switch to the inside of the outboard seat cushion side shield.
7. Remove the power seat switch from the outboard seat cushion side shield.
INSTALLATION
1. Position the power seat switch onto the outboard seat cushion side shield.
2. Install and tighten the two screws that secure the power seat switch to the inside of the outboard seat cushion side shield. Tighten the screws to 1.5
Nm (14 in. lbs.).
3. Reconnect the power seat wire harness connector to the power seat switch connector receptacle.
4. Position the outboard seat cushion side shield onto the seat cushion frame.
5. Install and tighten the three screws that secure the outboard seat cushion side shield to the seat cushion frame. Tighten the screws to 1.5 Nm (14
in. lbs.).
6. On models with the ten-way power seat system only, position the power seat and power recliner switch knobs onto the switch stems and push on
them firmly and evenly until they snap into place.
7. Reconnect the battery negative cable.
