Grand Cherokee 2WD V8-4.7L VIN N (2000)
Brake Pedal Assy: Service and Repair
REMOVAL
1. Remove retainer clip that holds booster to pedal pin.
2. Remove nut from pedal shaft.
3. Slide pedal shaft out and remove brake pedal.
4. Remove pedal bushings if they are to be replaced.
INSTALLATION
1. Lubricate bushings, pedal shaft and pedal pin with Mopar multi-mileage grease.
2. Install bushings into pedal.
3. Position pedal in bracket and install pedal shaft in support and through pedal.
4. Install new nut on pedal shaft and tighten to 27 Nm (20 ft. lbs.).
NOTE: Pedal shaft nut should not be reused.
