Grand Cherokee 2WD V8-4.7L VIN N (2000)
Outboard Brake Shoe
10. Remove the outboard brake shoe from the caliper anchor.
INSTALLATION
1. Install the inboard brake shoe onto the caliper.
2. Install the outboard shoe onto the caliper anchor.
3. Lubricate the slide pins and slide pin bushings with Dow Corning@ grease G807 or the grease provided with the brake shoes.
4. Install caliper on the caliper anchor.
5. Install the caliper slide pin and tighten to 29 - 41 Nm (21 - 30 ft. lbs.).
6. Install the caliper slide pin bushing caps.
7. Install the caliper support spring in the top end of the caliper and under the anchor. Then install other end into the lower caliper hole. Hold the
spring into the caliper hole with your thumb while prying the end of the spring out and down under the anchor with a screw drive.
8. Install wheel and tire assembly.
9. Remove support and lower vehicle.
10. Pump brake pedal until caliper pistons and brake shoes are seated and a firm brake pedal is obtained.
11. Fill brake fluid.
