Grand Cherokee 2WD V8-4.7L VIN N (2000)
DO NOT APPLY A LOAD TO THE FLEXIBLE RUBBER BRAKE HOSE DURING THIS CLEANING OPERATION OR PERMANENT
DAMAGE TO THE HOSE MAY RESULT.
18.
Remove the protective paper covering the adhesive on the outboard surface of the new outer brake pad insulator. Carefully position the outer brake
pad to the caliper (Fig. 3). The wear indicator should be located on the leading edge of the outer brake pad. When the pad is properly centered on
the caliper, press it firmly against the fingers and hold for 10 seconds. This will insure proper adhesion of the brake pad to the caliper fingers.
Final adhesion will be accomplished when the brake pedal is fully applied after assembly.
19.
Coat the brake pad contact rail surfaces of the caliper anchor with the Plastilube (brown color) grease provided in the kit.
NOTE:
DO NOT APPLY GREASE TO ANY PORTION OF THE CALIPER, BRAKE PAD LININGS, OR ROTOR.
