Grand Cherokee 2WD V8-4.7L VIN N (2000)
Servo Cable Clip Remove/Install - Typical
11. If servo is being removed from its mounting bracket, remove 2 mounting nuts holding servo cable sleeve to bracket.
12. Pull speed control cable sleeve and servo away from servo mounting bracket to expose cable retaining clip and remove clip. Note: The servo
mounting bracket displayed in is a typical bracket and may/may not be applicable to this model vehicle.
13. Remove servo from mounting bracket or, remove servo and mounting bracket as one assembly.
INSTALLATION
1. Position servo to mounting bracket.
2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip.
3. Insert servo mounting studs through holes in servo mounting bracket.
4. Install servo cable mounting nuts and tighten to 8.5 Nm (75 in. lbs.) torque. If servo and bracket is being installed as one assembly, install 2
mounting nuts and tighten to 28 Nm ± 6 Nm (250 in. lbs. ± 50 in. lbs.) torque.
5. Connect vacuum line at servo.
6. Connect electrical connector at servo.
7. Connect servo cable to throttle body.
8. Install battery tray and battery temperature sensor.
9. Connect wiring to battery tray.
10. Install battery to battery tray.
11. Connect positive battery cable to Power Distribution Center (PDC).
12. Connect positive battery cable to battery.
13. Connect negative battery cable to battery.
14. Before starting engine, operate accelerator pedal to check for any binding.
