Grand Cherokee 2WD V8-4.7L VIN N (2000)
Fig. 112
7. Install the bedplate retaining bolts, making sure to place the stud bolts in the correct location, Torque the bolts in the sequence shown (Fig. 112).
-
Tighten bolts A - L to 54 Nm (40 ft. lbs.)
-
Tighten bolts 1-10 to 2.8 Nm (25 in. lbs.)
-
Turn bolts 1-10 an additional 90°.
-
Tighten bolts At- A6 to 27 Nm (20 ft. lbs.)
8. Measure crankshaft end play. Refer to Crankshaft Main Bearings for procedure.
9. Install the connecting rods and measure side clearance. Refer to Connecting Rod Bearings for procedure.
10. Position the oil pan gasket/windage tray, using a new O-ring, install the oil pickup tube. Torque the bolt to 28 Nm (20 ft. lbs.) torque the nuts to
28 Nm (20 ft. lbs.).
Fig. 113
11. Install the oil pan. Torque the retaining bolts to 15 Nm (11 ft. lbs.) in the sequence shown (Fig. 113).
12. Install the engine.
