Grand Cherokee 2WD V8-4.7L VIN N (2000)
Fig. 43
21. reverse order of tightening sequence (Fig. 43).
NOTE: Intake must be lifted upward and level in the front and rear to clear the cowl. Interference with the cowl will occur during removal.
22. Remove intake manifold.
INSTALLATION
1. Install intake manifold gaskets.
2. Install intake manifold.
3. Install intake manifold retaining bolts and tighten in sequence shown in (Fig. 43) to 12 Nm (105 in. lbs.)
4. Install left and right radio suppressor straps.
5. Install throttle body assembly.
6. Install throttle cable bracket.
7. Connect throttle cable and speed control cable to throttle body.
8. Install fuel rail.
9. Install ignition coil towers.
10. Install coolant temperature sensor.
11. Connect electrical connectors for the following components:
-
Manifold Absolute Pressure (MAP) Sensor
-
Intake Air Temperature (TAT) Sensor
-
Throttle Position (TPS) Sensor
-
Coolant Temperature (CTS) Sensor
-
Idle Air Control (IAC) Motor
-
Ignition coil towers
-
Fuel injectors
12. Install top oil dipstick tube retaining bolt and ground strap.
13. Install right side engine lifting stud.
14. Install generator including electrical connections.
15. Connect Vapor purge hose, Brake booster hose, Speed control servo hose, Positive crankcase ventilation (PCV) hose.
16. Install air conditioning compressor including electrical connections.
17. Fill cooling system. Refer to Cooling System for procedure.
18. Install accessory drive belt.
19. Install cowl to hood seal.
20. Install air cleaner housing and throttle body resonator. Tighten resonator bolts 4.5 Nm (40 in. lbs.).
21. Connect negative cable to battery.
