Grand Cherokee 2WD V8-4.7L VIN N (2000)
7. Remove heat shield.
8. Lower vehicle and remove the upper exhaust manifold retaining bolts.
9. Raise vehicle and remove the lower exhaust manifold retaining bolts.
10. Remove exhaust manifold and gasket. Manifold is removed from below the engine compartment.
INSTALLATION
1. Install exhaust manifold and gasket from below engine compartment.
2. Install lower exhaust manifold fasteners. DO NOT tighten until all fasteners are in place.
3. Lower vehicle and install upper exhaust manifold fasteners.
Tighten all manifold bolts starting at center and working outward to 25 Nm (18 ft. lbs.).
CAUTION: Over tightening heat shield fasteners, may cause shield to distorx and/or crack.
4. Install exhaust manifold heat shield.
Tighten fasteners to 8 Nm (72 inch lbs.), then loosen 45 degrees.
5. Install air cleaner housing and tube.
6. Connect exhaust pipe to manifold.
7. Connect negative cable to battery.
