Grand Cherokee 2WD V8-4.7L VIN N (2000)
Control Assembly: Service and Repair
A/C Heater Control
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE
ATTEMPTING ANY STEERING WHEEL; STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE.
FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE
PERSONAL INJURY.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the inboard switch pod bezel from the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair
Heater-A/C Control Remove/Install
3. Remove the 4 screws that secure the heater- A/C control to the instrument panel.
4. Pull the heater-A/C control assembly away from the instrument panel far enough to access the connections on the back of the control.
Heater-A/C Control Connections
5. Unplug the wire and/or vacuum harness connectors from the back of the heater-A/C control.
6. Remove the heater-A/C control from the instrument panel.
INSTALLATION
1. Plug the wire harness and/or vacuum harness connectors into the back of the heater-A/C control.
2. Position the heater-A/C control in the instrument panel and secure it with 4 screws. Tighten the screws to 2.2 Nm (20 in. lbs.).
3. Reinstall the inboard switch pod bezel onto the instrument panel. See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair
4. Connect the battery negative cable.
