Grand Cherokee 2WD V8-4.7L VIN N (2000)
Hose/Line HVAC: Service and Repair
A/C Liquid Hose/Line Replacement
Any kinks or sharp bends in the refrigerant plumbing will reduce the capacity of the entire air conditioning system. Kinks and sharp bends reduce the
flow of refrigerant in the system. High pressures are produced in the refrigerant system when the air conditioning compressor is operating. Extreme care
must be exercised to make sure that each of the refrigerant system connections is pressure-tight and leak free.
WARNING: REVIEW THE WARNINGS AND CAUTIONS BEFORE PERFORMING THE FOLLOWING OPERATION.
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Recover the refrigerant from the refrigerant system.
3. Unsnap the plastic retainer clips that secure the liquid line to the inner fender shield and the dash panel in the engine compartment.
4. Disengage the liquid line from the plastic retainer clips.
5. Disconnect the liquid line refrigerant line fitting from the evaporator inlet tube. Install plugs in, or tape over all of the opened refrigerant line
fittings.
6. Disconnect the liquid line from the condenser outlet tube refrigerant line fitting. Install plugs in, or tape over all of the opened refrigerant line
fittings.
7. Remove the liquid line from the plastic clip that secures it to the right inner fender shield.
8. Remove the liquid line from the vehicle.
INSTALLATION
1. Remove the tape or plugs from the refrigerant line fittings on the condenser outlet tube and the condenser end of the liquid line.
2. Remove the tape or plugs from the refrigerant line fittings on the evaporator end of the liquid line and from the evaporator inlet tube.
3. Install the liquid line into the plastic retainer clips that secure it to the inner fender shield and the dash panel and snap the retainer clips closed.
4. Connect the battery negative cable.
5. Evacuate the refrigerant system.
6. Charge the refrigerant system.
