Grand Cherokee 2WD V8-4.7L VIN N (2000)
Electronic Vehicle Information Center Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console from the headliner.
Electronic Vehicle Information Center Remove/Install
3. Remove the four screws that secure the Electronic Vehicle Information Center (EVIC) module to the overhead console housing.
4. Remove the EVIC module from the overhead console housing.
INSTALLATION
1. Position the EVIC module onto the overhead console housing.
2. Install and tighten the four screws that secure the EVIC module to the overhead console housing. Tighten the screws to 0.9 Nm (8 in. lbs.).
3. Install the overhead console onto the headliner.
4. Reconnect the battery negative cable.
NOTE: If a new compass mini-trip computer has been installed, the compass will have to be calibrated and the variance set. Refer to Compass
Variation Adjustment and Compass Calibration.
Ambient Temperature Sensor Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
