Grand Cherokee 2WD V8-4.7L VIN N (2000)
Power Distribution Center Remove/Install
8. Disengage the latches on the PDC housing mounts from the tabs on the PDC mounting stanchions of the battery support, and pull the PDC housing
upward to disengage the mounts from the stanchions.
9. Remove the PDC and the right headlamp and dash wire harness from the engine compartment as a unit.
INSTALLATION
1. Position the PDC and the right headlamp and dash wire harness unit in the engine compartment.
2. Engage the PDC housing mounts with the stanchions of the battery support and push the unit downward until the mount latches fully engage the
mounting tabs on the stanchions.
3. Install the two-holed eyelet of the battery wire harness PDC take outs onto the two PDC B(+) terminal studs.
4. Install and tighten the nuts that secure the eyelet of the battery wire harness PDC take outs to the B(+) terminal studs. Tighten the nuts to 11.3 Nm
(100 in. lbs.).
5. Engage each of the retainers that secure the right headlamp and dash wire harness to the vehicle body and chassis components.
6. Install all of the fasteners that secure each of the right headlamp and dash wire harness ground eyelets to the vehicle body and chassis components.
7. Reconnect each of the right headlamp and dash wire harness connectors. Refer to Connector Locations for more information on the right headlamp
and dash wire harness connector locations. For connectors secured with screws, tighten the screws to 4.3 Nm (38 in. lbs.).
8. Reconnect the battery negative cable.
