Grand Cherokee 2WD V8-4.7L VIN N (2000)
Fig. 16 EVAP Canister Removal/Installation
3. Remove 2 canister mounting bolts at front mounting bracket.
4. Remove canister from rear mounting bracket (2 pins are used to align canister to rear bracket)
INSTALLATION
1. Position canister to body. Guide pins into rear bracket.
2. Install canister mounting bolts. Tighten bolts to 11 Nm (100 in. lbs.) torque.
3. Connect vacuum lines. Be sure vacuum lines are firmly connected and not leaking or damaged. If leaking, a Diagnostic Trouble Code (DTC) may
be set with certain emission packages.
4. Install duty cycle EVAP canister purge solenoid and its mounting bracket to front of EVAP canister (2 nuts). Tighten nuts to 9 Nm (80 in. lbs.)
torque.
