Grand Cherokee 2WD V8-4.7L VIN N (2000)
1. Perform Fuel System Pressure Release Procedure.
2. Disconnect negative battery cable at battery.
3. Raise vehicle.
4. Clean area around 3 filter/regulator fittings.
5. Disconnect fuel supply, fuel return and fuel pressure lines at filter/regulator (Fig. 25). Refer to Quick-Connect Fittings.
6. Remove 2 mounting bolts (Fig. 26) and remove filter/regulator.
INSTALLATION
1. Before installing filter/regulator, be sure all fittings are cleaned of all dirt and contaminants.
2. Be sure O-ring is positioned into fuel return fitting in filter/regulator.
3. Apply a small amount of clean engine oil to O-rings.
4. Position filter/regulator to body and install 2 bolts. Tighten bolts to 3 Nm (30 in. lbs.) torque.
5. Connect 3 fittings. Refer to Quick-Connect Fittings.
6. Connect negative battery cable to battery.
7. Start engine and check for leaks.
