Grand Cherokee 2WD V8-4.7L VIN N (2000)
11.
Remove the jumper wires and connect the fuel injector electrical connector.
12.
Disconnect the negative battery cable.
NOTE:
To enhance customer satisfaction, remember to reset the clock when you have completed the service procedure.
13.
Install the fuel pump relay into the PDC.
14.
Raise the vehicle on the hoist.
15.
Working from the front of the fuel tank, loosen the fuel vent hose clamp at the fuel tank end of the hose, then remove the vent hose from the tank
fitting (Figure 2).
16.
Insert a length of 3/8" O.D. thinwall clear tubing (Tygon tubing) into the tank vent fitting.
17.
Attach the other end of the tubing to an approved gasoline storage container and drain the fuel from the tank into the container.
18.
Remove the rear tow hooks (if equipped).
19.
Remove the fuel tank-to-rear bumper fascia clips (Figure 3).
