Grand Cherokee 2WD V8-4.7L VIN N (2000)
Steering Wheel Armature Pockets
5. Pull the steering wheel off of the steering column upper shaft spline using a two-jawed puller (Special Tool C-3894-A). when installing the puller
onto the steering wheel, be certain that each jaw of the puller is seated in the pocket that is cast into the underside of the steering wheel armature
on each side of the hub. Also, if the clockspring is to be reused, be certain not to damage or deform the clockspring case when positioning the jaws
of the puller below the steering wheel armature hub.
Steering Column Shrouds Remove/Install
6. Remove the screw that secures the lower tilting steering column shroud to the steering column multifunction switch mounting housing.
7. Unsnap the two halves of the tilting steering column shroud from each other and remove both halves from the steering column.
8. Disconnect the two instrument panel wire harness connectors from the lower clockspring connector receptacles.
