Grand Cherokee 2WD V8-4.7L VIN N (2000)
1. Position tools as shown to remove and install ball stud.
KNUCKLE INSTALLATION
1. Position the steering knuckle on the ball studs.
2. Install and tighten the bottom retaining nut to 109 Nm (80 ft. lbs.) torque. Install new cotter pin.
3. Install and tighten the top retaining nut to 101 Nm (75 ft. lbs.) torque. Install new cotter pin.
4. Install the hub bearing and axle shaft.
5. Connect the tie-rod or drag link end to the steering knuckle arm.
