Grand Cherokee 2WD V8-4.7L VIN N (2000)
Fig. 58
11. Slowly tighten the nut in 6.8 Nm (5 ft. lbs.) increments until the rotating torque is achieved. Measure the rotating torque frequently to avoid over
crushing the collapsible spacer (Fig. 58).
12. Rotate the pinion a minimum of ten times. Make sure that the pinion rotates smoothly. Check bearing rotating torque with an inch pound torque
wrench (Fig. 58). The torque necessary to rotate the pinion gear should be:
-
Original Bearings - 1 to 2 Nm (10 to 20 inch lbs.).
-
New Bearings - 2.8 to 4 Nm (25 to 35 inch lbs.).
13. Align previously made marks on yoke and propeller shaft and install propeller shaft.
14. Install differential housing into the axle housing.
