Grand Cherokee 2WD V8-4.7L VIN N (2000)
PARTS REQUIRED
EQUIPMENT REQUIRED
NOTE:
THE MDS2 AND DRBIII(R) ARE REQUIRED TO PERFORM PART OF THIS REPAIR. WHEN USING THE MDS2 AND THE DRBIII(R),
THE SYSTEM MUST BE OPERATING AT CIS CD 2062 OR HIGHER.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
P8 - New Part
FM - Flash Module
Front Propeller Shaft Replacement
NOTE:
DO NOT EXECUTE THIS REPAIR PROCEDURE UNLESS THE CORRECT EQUIPMENT IS USED. PAY CLOSE ATTENTION TO REPAIR
PROCEDURE.
NOTE:
DO NOT USE AN IMPACT WRENCH TO TIGHTEN THE PINION OR TRANSFER CASE NUTS.
1.
Raise and support the vehicle on safety stands. Make sure the steering wheel is centered.
2.
Shift the transmission and transfer case, if necessary, into the Neutral position.
3.
Remove both front wheels and tires from their respective axle hub/bearing.
4.
Remove both front brake calipers from their anchors. Support the brake calipers in a correct manner so that, the caliper will not interfere with the
rotation of the axle shafts. Do not allow the brake hose to support the caliper weight.
5.
Make a mark so that the brake rotor and hub can be installed back to their original position to each other.
