Grand Cherokee 2WD V8-4.7L VIN N (2000)
Axle Pivot Bushing: Service and Repair
REMOVAL
1. Remove the upper suspension arm from axle.
2. Position Spacer 8279 over the axle bushing on a 4x2 vehicle and right side on a 4x4 vehicle.
Fig. 9
3. Place Receiver 7932-1 over flanged end of the bushing. (Fig. 9).
4. Place small end of Remover/Install 7932-2 against other side of the bushing.
5. Install bolt 7604 through remover, bushing and receiver.
6. Install Long Nut 7603 and tighten nut too pull bushing out of the axle bracket.
7. Remove nut, bolt, receiver, remover and bushing.
Note: On 4x2 vehicle and right side of 4x4 vehicle, leave Spacer 8279 in position for bushing installation.
INSTALLATION
1. Place Receiver 7932-1 on the other side of the axle bracket.
Fig. 10
2. Position new bushing up to the axle bracket., and large end of Remover/Install 7932-2 against the bushing (Fig. 10).
3. Install bolt 7604 through receiver, bushing and installer.
