Grand Cherokee 2WD V8-4.7L VIN N (2000)
Fig. 26
4. Using a suitable cold chisel, cut retaining ring across drilled hole. (Fig. 26)
5. Slide retaining ring from axle shaft.
Fig. 27
6. Using Splitter 1130 placed between the seal and bearing and a suitable Arbor Press, press bearing from the axle shaft (Fig. 27).
7. Slide seal from axle.
8. Slide retaining plate from axle shaft.
INSTALLATION
1. Using a suitable straight edge, verify flatness of axle shaft retaining plate. Replace plate if warped.
2. Install the studs back into the retaining plate. If the studs are loose in the plate, replace the retaining plate.
