Grand Cherokee 2WD V8-4.7L VIN N (2000)
Rear Washer Nozzle Plumbing
The headliner washer hose is serviced only as a unit with the headliner. If this washer hose is damaged or faulty, the headliner unit must be
replaced. The remaining washer hoses for the rear washer nozzle plumbing are available for service replacement. The check valve for the rear
washer nozzle is integral to the nozzle.
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry at the sides of the rear washer nozzle to release the latches that secure it
to the liftgate outer panel.
Rear Washer Nozzle Plumbing
2. Pull the rear washer nozzle out from the liftgate outer panel far enough to access the washer supply hose.
3. Disconnect the washer supply hose from the barbed nipple of the rear washer nozzle.
4. Remove the rear washer nozzle from the lift- gate.
INSTALLATION
Windshield
1. From the top side of the cowl grille cover, insert the nipple end of the windshield washer nozzle through the mounting hole in the cowl grille
cover.
2. Push firmly and evenly on the top of the windshield washer nozzle until the latches snap into place on the underside of the cowl grille cover.
3. From the underside of the cowl grille cover, reconnect the washer hose(s) to the barbed nipple(s) of the windshield washer nozzle(s) or the
combination wye fitting/check valve unit.
4. Install the washer hoses for the windshield washer nozzles or the combination wye fitting/check valve unit into their routing clips on the
