Grand Cherokee 2WD V8-4.7L VIN N (2000)
underside of the cowl grille cover.
5. Position the cowl grille cover onto the cowl plenum and cowl top panels through the opening between the hood and the windshield.
6. Lift the left end of the cowl grille cover off of the cowl plenum panel far enough to access the windshield washer plumbing.
7. Reconnect the windshield washer supply hose at the in-line connector.
8. Install the six plastic nuts that secure the cowl grille cover to the studs on the cowl top panel near the base of the windshield. These nuts are to
be installed by pushing them onto the studs in the following sequence:
a. First, install the short nuts to the third stud from the right, then the second stud from the left.
b. Next, install long nuts to the right outboard stud, then the left outboard stud.
c. Finally, install the two remaining long nuts to the third stud from the left, then the second stud from the right.
9. Starting at the ends and working toward the center, push the hood to plenum seal onto the forward flanges of the cowl grille cover and the
plenum panel.
10. Install the wiper arms onto the wiper pivots.
11. Reconnect and isolate the battery negative cable.
Rear
1. Position the rear washer nozzle to the liftgate.
2. Reconnect the washer supply hose to the barbed nipple of the rear washer nozzle.
3. Insert the rear washer nozzle supply hose and nipple into the mounting hole in the liftgate outer panel.
4. Push firmly and evenly on the rear washer nozzle until the latches snap into place on the inside of the liftgate outer panel mounting hole.
