Grand Cherokee 2WD V8-4.7L VIN N (2000)
Wiper Motor: Service and Repair
Rear Wiper Motor Module Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. From the outside of the liftgate, remove the rear wiper arm from the rear wiper motor output shaft.
Rear Wiper Motor Output Shaft Remove/Install
3. Use a door trim panel removal tool to gently pry at the base of the nut cover where it meets the wiper motor output shaft bezel and grommet on the
outer liftgate panel until it unsnaps from the rear wiper motor output shaft. Be certain to use proper caution to protect the outer liftgate panel and
its paint finish from damage during this procedure.
4. Remove the nut that secures the rear wiper motor output shaft to the outer liftgate panel.
5. Remove the bezel and gasket from the rear wiper motor output shaft.
6. Remove the trim panel from the inside of the liftgate.
Rear Wiper Motor Module Remove/Install
