Grand Cherokee 2WD V8-4.7L VIN N (2000)
Wiper Motor: Service and Repair
Windshield Wiper Motor, Pivot and Linkage Module Replacement
Windshield Wiper Motor, Pivot and Linkage Module Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Remove the wiper arms from the wiper pivots.
3. Open the hood and pull the hood to plenum seal off of the forward flanges of the cowl grille cover and the plenum panel.
Cowl Grille Cover Remove/Install
4. Remove the six plastic nuts (2 short and 4 long) that secure the cowl grille cover to the studs on the cowl top panel near the base of the windshield.
5. Lift the left end of the cowl grille cover off of the cowl plenum panel far enough to access the windshield washer plumbing.
6. Disconnect the windshield washer supply hose at the in-line connector.
7. Remove the cowl grille cover from the cowl plenum and cowl top panels through the opening between the hood and the windshield.
Wiper Motor, Pivot And Linkage Module Remove/Install
8. Remove the four screws that secure the wiper motor, pivot and linkage module to the cowl plenum panel.
9. Lift the left end of the wiper motor, pivot and linkage module far enough to access the wiper motor wire harness connector.
