Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Power Seat Switch: Service and Repair
Power Seat Switch
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick or another suitable wide flat-bladed tool, gently pry the power seat and power recliner switch knobs off of the switch stems.
3. Remove the three screws that secure the seat cushion side shield to the outboard seat cushion frame.
4. Pull the seat cushion side shield away from the seat cushion frame far enough to access the power seat switch and power lumbar switch wire
harness connectors.
5. Unplug the wire harness connectors from the power seat and power lumbar switches.
Power Seat Switches Remove/Install
6. Remove the seat cushion side shield from the vehicle.
7. Remove the two screws that secure the power seat switch to the inside of the seat cushion side shield.
8. Remove the power seat switch from the seat cushion side shield.
9. Reverse the removal procedures to install. Tighten the mounting screws to 2.2 N.m (20 in. lbs.).