Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Lever Boot Installation
3. Install new boot on caliper bracket. Metal retainer part of boot fits over ledge on caliper as shown. Rubber part of boot extends through rear
opening in bracket. Allow adhesive on boot and bracket to set up for a minute or two before proceeding.
CAUTION: If the boot is not installed properly, it will prevent the shield from seating squarely on the bracket. This will cock the shield causing it
to rub against the rotor after installation.
4. Position splash shield on caliper bracket. Then carefully install shield and bracket assembly on axle tube flange studs.
5. Apply Mopar Lock N' Seal or Loctite 242 to the axle tube stud nuts. Then install and tighten nuts to 43 - 61 Nm (32 - 45 ft. lbs.).
Cam And Lever Installation
6. Assemble and install cam and lever. Push lever through boot and seat cam between lip on shield and ledge on bracket. Then engage lever in cable
eyelet. Be sure cable notch in lever is facing rearward. Remove and reposition cam and lever if necessary.
