Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Brake Proportioning/Combination Valve: Service and Repair
REMOVAL
1. Remove brake lines that connect master cylinder to combination valve.
2. Disconnect brake lines that connect combination valve to Hydraulic Control Unit (HCU).
3. Disconnect wire from combination valve switch terminal. Be careful when separating wire connector as lock tabs are easily damaged if not fully
disengaged.
4. Remove nuts attaching combination valve bracket to booster studs and valve bracket off booster studs.
INSTALLATION
1. Position valve bracket on booster studs and tighten bracket attaching nuts to 18 Nm (155 inch lbs.).
2. Align and start all four brake line fittings in combination valve by hand to avoid cross threading. Then tighten fittings just enough to prevent
leakage.
3. Connect wire to differential pressure switch in combination valve.
4. Tighten brake line fittings at master cylinder just enough to prevent leakage.
5. Bleed brakes.