Grand Cherokee 2WD V8-5.2L VIN Y (1998)
(4) Reverse the removal procedures to install.
Power Outlet Door
POWER OUTLET DOOR
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
(1) Insert a trim stick or other suitable wide flat-bladed tool between the side of the power outlet housing in the instrument panel center bezel and the
upper pivot area of the power outlet door.
(2) Pry gently against the upper pivot area of the power outlet door until the door pivot pin clears the pivot receptacle in the instrument panel center
bezel.
(3) Pull the power outlet door out of the power outlet housing.
(4) To install the door, insert one of the pivot pins into a pivot receptacle in the center bezel and twist the door gently until the pivot pin on the opposite
side of the door snaps into the other pivot receptacle.
Cowl Top Trim Panel
COWL TOP TRIM PANEL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
(1) Disconnect and isolate the battery negative cable.
Cowl Top Trim Remove/Install
(2) Using a wide flat-bladed tool such as a trim stick, pry the cowl top trim panel off of the instrument panel top pad.
(3) Pull the panel up far enough to unplug the wiring connector for the solar sensor, or to remove the solar sensor from the cowl top trim between the
right and center defroster outlets, if so equipped.
(4) Remove the cowl top trim panel from the vehicle.
(5) Reverse the removal procedures to install.
Instrument Panel Top Pad
INSTRUMENT PANEL TOP PAD
