Grand Cherokee 2WD V8-5.2L VIN Y (1998)
column far enough to move the upper fixed column shroud.
Multi-function Switch Connector - Typical
12. Move the upper fixed column shroud far enough to access the rear of the multi-function switch.
13. Remove the tamper proof mounting screws (a Snap On tamper proof torx bit TTXR20B2 or equivalent is required) that secure the multi-function
switch to the steering column.
14. Gently pull the switch away from the steering column far enough to access and loosen the multi- function switch wire harness connector screw.
The screw will remain in the wire harness connector.
15. Unplug the wire harness connector from the multi-function switch.
16. Reverse the removal procedures to install. Tighten the fasteners as follows:
-
Multi-function switch wire harness connector screw - 2 N.m (17 in. lbs.)
-
Multi-function switch mounting screws - 2 N.m (17 in. lbs.)
-
Steering column mounting nuts - 12 N.m (110 in. lbs.).