Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Trunk/Liftgate Sensor/Switch (For Alarm): Service and Repair
Liftgate Ajar Switch
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open the liftgate.
3. Remove the screws that secure the liftgate lower trim panel to the liftgate inner panel.
4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the perimeter edges of the trim panel away from the liftgate inner panel to
release the retainers.
NOTE: To aid in the removal of the trim panel, start at the bottom of the panel.
5. Remove the liftgate trim panel from the vehicle.
Liftgate Latch/Lock Components
6. Remove the three screws that secure the lift- gate latch to the liftgate.
7. Disconnect the liftgate handle latch actuator rod from the latch.
8. Unplug the liftgate ajar switch wire harness connector from the latch.
9. Remove the latch from the liftgate.
10. Reverse the removal procedures to install. Tighten the latch mounting screws to 7 N.m (62 in lbs.).