Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Power Steering Pump: Service and Repair
Power Steering Pump Removal and Installation
REMOVAL
1. Remove the serpentine drive belt.
2. Remove the pressure and return hoses from pump and drain pump.
3. Vehicles equipped with Speed Proportional Steering, disconnect actuator harness.
4. Remove pump mounting bolts and remove the pump.
5. Remove pulley from pump.
INSTALLATION
1. Install pulley on pump.
2. Mount pump on bracket and install bolts. Tighten bolts to 27 Nm (20 ft. lbs.).
3. Install the pressure and return hoses to pump.
4. Vehicles equipped with Speed Pro Steering, connect actuator harness.
5. Install drive belt.
6. Add power steering fluid. Refer to Initial Operation.
