Grand Cherokee 2WD V8-5.2L VIN Y (1998)
Rear Clutch Components
13. Install first clutch disc followed by steel plate until all discs and plates are installed. 4 clutch discs and steel plates are required.
14. Install reaction plate on top of last clutch disc.
15. Install selective snap ring to secure clutch pack in retainer.
Input Shaft Seal Ring Locations
16. Install new seal rings on input shaft if necessary. Be very sure ring ends are all securely hooked together before proceeding.
Measuring Rear Clutch Pack Clearance
17. Check clutch pack clearance with feeler gauge. Clearance should be 0.63 to 1.14 mm (0.025 to 0.045 inch).
18. If clutch pack clearance is incorrect, clutch pack snap ring may have to be replaced.
19. Install thrust washer on piston retainer hub. Use petroleum jelly to hold thrust washer in place.