Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
SPECIAL TOOLS/EQUIPMENT REQUIRED:
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
Repair Procedure
1.
Open the liftgate.
2.
Remove the four push pin fasteners (reuseable) and two screws in the step pad area.
3.
At the left rear wheel opening, remove the three plastic rivets used to secure the leading edge of the rear fascia to the left rear wheel opening splash
shield.
4.
Remove the two push pin fasteners (reuseable) securing the left rear splash shield to the body. Remove the left rear splash shield.
5.
Behind where the splash shield was positioned, remove the nut on the back side of the quarter panel used to secure the left side of the fascia to the
body.
6.
At the right rear wheel opening, remove the three plastic rivets, two push pins (reuseable), splash shield, and nut.
7.
Disconnect the electrical harness connector at the right side of the rear fascia.
8.
Remove the rear fascia and place face (outside surface) down on a protective surface.
9.
Remove the four push pins (reuseable) at the bottom of the fascia that are used to secure the energy absorber. Carefully remove the energy
absorber from the back of the rear fascia.
10.
Do not disconnect the Park Assist sensors from their electrical connectors.
11.
Starting at one end, remove one Park Assist sensor from its bracket.
NOTE:
Do not remove sensor bracket from the applique. Remove the sensor from its individual bracket.
12.
Remove the old sensor spacer. With a clean rag thoroughly clean the sensor face and side, and the opening in the bracket for the sensor.
