Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
7. Carefully pull the rear edge of the headliner downward from the header far enough to access and remove the two nuts (2) and one bolt (3) that
secure the hinge studs to the underside of the header.
8. Remove the hinge from the vehicle.
INSTALLATION
NOTE:
-
It is not necessary to remove the liftgate to replace one or both hinges. The hinges can be replaced one at a time.
-
Use a suitable body sealer on the hinge to body mating surfaces prior to installation.
1. Position the body half of the liftgate hinge (1) to the upper liftgate opening header on the vehicle.
2. Carefully pull the rear edge of the headliner downward from the header far enough to install and tighten the two nuts (2) and one bolt (3) that
secure the hinge to the underside of the header.
3. Tighten the fasteners to 28 N.m (21 ft.lbs.).
