Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
16. Secure the steering wheel in the straight ahead position.
17. Remove the steering gear as necessary.
18. Support the cradle with suitable lifting device.
19. Using a grease pencil or equivalent, mark the location of the engine support cradle on the underbody.
20. Remove the four bolts at each corner and lower the cradle.
21. Remove the lower control arms.
22. Remove the sway bar.
INSTALLATION
1. Install the sway bar onto the engine cradle as necessary.
2. Install the lower control arms as necessary.
3. Raise the engine cradle into position guiding the engine mount bolts into the engine cradle slots.
4. Install the four engine cradle bolts (1 & 2).
5. Align the engine cradle to the marks made during removal and tighten the front bolts (1) to 203 N.m (150 ft.lbs.).
6. Tighten the rear bolts (2) to 122 N.m (90 ft.lbs.).
7. Install the steering gear as necessary.
8. Lower the engine fully onto the engine mounts.
