Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. Reconnect the wheel speed sensor wire connector (1).
2. Reroute and connect the wheel speed sensor wire to the routing clips (2).
3. Install the wheel speed sensor into the hub (3) and the install the mounting nut (2) and tighten the nut to 12 - 14 Nm (106 - 124 inch lbs.).
4. Check the sensor wire routing (1). Be sure the wire is clear of all chassis components and is not twisted or kinked at any spot.
5. Install the disc brake rotor. See: Disc Brake System/Brake Rotor/Disc
6. Install the caliper adaptor over the rotor.
7. Install the caliper adaptor bolts and tighten to 90 - 115 Nm (66 - 85 ft. lbs.) See: Disc Brake System/Brake Caliper
8. Install the tire and wheel assembly.
9. Remove the support and lower vehicle.
