Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
^
54 mm caliper: Installer C-3716-A
7. Install the second piston and dust boot.
8. Lubricate caliper mounting bolt bushings, boot seals and bores with Mopar brake grease or Dow Corning 807 grease only.
CAUTION: Use of alternative grease may cause damage to the boots seals.
9. Install the boot seals into the caliper seal bores and center the seals in the bores.
10. Install mounting bolt bushings into the boot seals and insure seal lip is engaged into the bushing grooves at either end of the bushing.
11. Install caliper bleed screw.
INSTALLATION
1. Install the brake pads.
2. Lubricate the slide pins and slide pin bushings with caliper slide grease or the grease provided with the caliper.
3. Install the caliper (1) on the anchor.
4. Install the caliper slide pin bolts (4) and tighten to 35 Nm (26 ft. lbs.).
CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.
5. Install brake hose (3) to caliper with a new gasket washers and tighten banjo bolt (5) to 31 Nm (23 ft. lbs.).
6. Fill and bleed brake system.
7. Install wheel and tire assemblies.
8. Remove supports and lower vehicle.
