Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Brake Fluid Pressure Sensor/Switch: Service and Repair
SENSOR-BRAKE PRESSURE
REMOVAL
1. Disconnect wiring harness (4) connector from pressure switch (5).
2. Remove pressure switch (5) on bottom of master cylinder.
INSTALLATION
1. Install pressure switch (5) on bottom of master cylinder. Tighten switch to 28 Nm (250 inch lbs.) torque.
2. Connect wiring harness (4) connector to pressure switch (5).
3. Fill master cylinder fluid reservoir (2) with clean, fresh Mopar Brake Fluid or equivalent.
4. Perform Verification Test and clear any faults.
