Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
15. Remove the oil pan mounting bolts using the sequence provided, and oil pan.
NOTE: When the oil pan is removed, a new oil pan gasket/windage tray assembly must be installed. The old gasket cannot be reused.
16. Discard the integral windage tray and gasket and replace.
INSTALLATION
1. Clean the oil pan gasket mating surface of the block and oil pan.
NOTE: Mopar Engine RTV must be applied to the 4 T-joints, (area where front cover, rear retainer, block, and oil pan gasket meet). The bead of
RTV should cover the bottom of the gasket. This area is approximately 4.5 mm x 25 mm in each of the 4 T-joint locations.
2. Apply Mopar ~ Engine RTV at the 4 T-joints.
NOTE: When the oil pan is removed, a new oil pan gasket/windage tray assembly must be installed. The old gasket cannot be reused.
3. Install a new oil pan gasket/windage tray assembly.
4. If removed, reinstall the oil pump pickup tube with new O-ring. Tighten tube to pump fasteners to 28 Nm (250 inch lbs.).
