Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
1. Disconnect and isolate the negative battery cable.
2. Remove the glove box from the instrument panel. Refer to Body and Frame/ Interior Trim/ Glove Compartment/ Service and Repair/ Procedures.
See: Body and Frame/Interior Moulding / Trim/Glove Compartment/Service and Repair
3. Remove the three screws (1) that secure the blend door actuator (2) to the passenger side of the HVAC air distribution housing (3).
4. Remove the blend door actuator from the air distribution housing and disconnect the HVAC wire harness connector (4) from the actuator.
5. Remove the blend door actuator from the vehicle.
INSTALLATION
NOTE: The single zone heater-A/C system is equipped with a single blend door actuator. The dual zone system has two blend door actuators, one for
the driver side blend-air door and one for the passenger side blend-air door.
1. Position the blend door actuator (1) into the vehicle.
2. Install the blend door actuator onto the passenger side of the HVAC air distribution housing (2). If necessary, rotate the actuator slightly to align
the splines on the actuator output shaft (3) with those on the blend door cam (4).
