Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
8. Disengage the two liquid line retainer clips (4) from the right frame rail (3). If required remove the clips from the liquid line
9. Disconnect the A/C liquid line (1) from the A/C expansion valve (2) and remove and discard the O-ring seal.
10. Install plugs in, or tape over the opened liquid and suction line fittings and the receiver/drier and expansion valve ports.
11. Remove the A/C liquid line from the engine compartment.
INSTALLATION
1. Position the A/C liquid line (1) into the engine compartment.
2. Remove the tape or plugs from the opened liquid and suction line fittings and the receiver/drier and expansion valve ports.
3. Lubricate a new O-ring seal with clean refrigerant oil and install it onto the rear liquid line fitting. Use only the specified seal as it is made of a
special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
4. Connect the A/C liquid line to the A/C expansion valve (2) and engage the two liquid line retainer clips (4) to the frame rail (3).
