Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
c.
Follow the on screen instructions. Select "Next" # after each step. Select "Finish" after completing the last step.
d.
At the "Flash File List" screen, highlight the appropriate EOM "Calibration".
e.
Select "Download to Scantool".
f.
When the download is complete, select "Close".
13.
Download the file from the StarSCAN(R) to the vehicle. Using the StarSCAN(R) at the "Home" screen:
a.
Select "ECU View".
b.
Browse the list of controllers using the scroll arrows. Highlight the EOM.
c.
Select "More Options".
d.
Select "ECU Flash".
e.
Highlight the appropriate EOM "Calibration" from the list.
f.
Select "Update Controller".
g.
When update is completed, select "OK".
NOTE:
Due to the EOM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle, if so equipped.
Some DTC's may cause the MIL to illuminate. Check all modules using "ECU View" from the Home screen, record the DTC's, and erase these
DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased. From the
"Home" screen select "System View", then select "All DTC's". Select the "Clear All Stored DTC's" if there are any DTC's stored.
14.
Use the procedures outline in TechCONNECT, 8-Electrical/Overhead Console/Electronic Vehicle Info Center/Standard Procedure, to reprogram
the compass variance and compass calibration.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.
