Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Driver/Vehicle Information Display: Service and Repair
Erasing Transmitter Codes
NOTE: Individual channels cannot be erased. Erasing the transmitter codes will erase ALL programmed codes.
To erase programming from the three buttons (individual buttons cannot be erased but can be "reprogrammed" - note below), follow the step noted:
-
Press and hold the two outer HomeLink buttons and release only when the Electronic Vehicle Information Center (EVIC) display shows "Channels
Cleared" (after 20 seconds). Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and
can be programmed at any time.
