Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
b. Rotating Tool Tire Changers - Position the wheel on the changer so that the sensor valve stem (1) is located approximately 210° clockwise
from the installation end of the mounting/dismounting tool (2) once the tool is mounted for tire installation. Make sure the sensor is clear of the
lower bead breaker area (3) to avoid damaging the sensor when the breaker rises. Rotate the tool (2) in a counterclockwise direction to mount
the tire. Use this procedure on both the upper and lower tire beads.
6. Adjust air pressure to that listed on Tire Inflation Pressure Label (Placard) provided with vehicle (usually applied to driver's side B-pillar). Make
sure original style valve stem cap is securely installed to keep moisture out of sensor.
7. Install tire and wheel assembly on vehicle.
8. Lower vehicle.
9. Drive vehicle for a minimum of five minutes while maintaining a continuous speed above 20 mph (32 km/h). During this time the system will
learn the new sensor ID code and will clear any DTC's automatically.
CAUTION: If a sensor cannot be trained, refer to appropriate diagnostic information.
