Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
Evaporative Emission Control Canister: Service and Repair
REMOVAL
The NVLD pump (2) is attached to the EVAP canister (3). This assembly is located in the left-rear quarterpanel behind the left-rear tire.
1. Raise and support vehicle.
2. Remove left-rear tire.
3. To access EVAP canister or NVLD pump, remove plastic splash shield at rear of left-rear tire.
4. Disconnect electrical connector (4) at pump.
5. Carefully remove vapor/vacuum hoses (1) and (6) at pump.
6. Remove three canister bracket-to-body nuts (1) and (2).
7. Separate canister from mounting bracket by removing two canister-to-bracket nuts at front of canister (4). The opposite end of canister is equipped
with two alignment pins. Remove canister from support bracket by pulling these two pins from the two rubber grommets
To Separate NVLD Pump from EVAP canister:
