Grand Cherokee 2WD V8-5.7L VIN 2 (2005)
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an
accelerator pedal position sensor (6). The accelerator pedal is serviced as a complete assembly including the bracket.
1. Disconnect electrical connector (3) at APPS (6).
2. Remove two accelerator pedal mounting bracket nuts (4). Remove accelerator pedal assembly.
3. Remove three sensor-to-pedal nuts (5). Remove APPS from accelerator pedal assembly.
INSTALLATION
The following procedure applies only to vehicles without the Adjustable Pedal Package (code XAP). It also applies to vehicles equipped with an
accelerator pedal position sensor. The accelerator pedal is serviced as a complete assembly including the bracket.
1. Install APPS to pedal assembly and install three nuts (5).
2. Place accelerator pedal assembly over two mounting studs (1).
3. Install and tighten two mounting nuts (4). Refer to Torque Specifications.
4. Install electrical connector (3) to APPS (6).
5. Use a scan tool may to learn electrical parameters. Go to the Miscellaneous menu, and then select ETC Learn.
6. If the previous step is not performed, a Diagnostic Trouble Code (DTC) will be set.
7. If necessary, also use a scan tool to erase any Diagnostic Trouble Codes (DTCs) from PCM.
8. Before starting engine, operate accelerator pedal to check for any binding.
